Clear polycarbonate corner guards provide indestructible protection for your wall corners. Powerfully durable and perfect for high-impact environments, clear plastic corner guards are designed to blend in with any décor. Available in standard and custom lengths and 90°, 135°, and bullnose.
What's the difference between polycarbonate and vinyl materials?
The polycarbonate material has a smooth, glossy finish, and the vinyl material is textured with more of a matte finish.
Can I cut the polycarbonate corner guards down?
While it is possible, it is very difficult. We recommend ordering a custom size.
What kind of tape is used on the polycarbonate corner guards?
The polycarbonate corner guards use a clear acrylic double-sided adhesive with a clear PET film liner. The tape used on all polycarbonate corner guards is much thinner than the foam tape used on the vinyl corner guards in order to maintain clarity for clear corner guard installations. Please note that this tape should not be used if the wall surface is textured in any way (stucco, wallpaper, etc).
What is the radius of a bullnose corner guard?
Bullnose outside radius is 0.84″ and inside radius is 0.75″.
When should I use adhesive to install my corner guards?
Generally speaking, glue or adhesive should be used whenever you need a permanent or heavy-duty installation. Adhesive is a universal installation method that allows the user to make small adjustments during the install due to its long cure time. It is easy to administer and creates a strong bond on any wall surface.
Wall surfaces must be clean, dry, and free from dust and grease. Wipe the wall surface with a solvent to assure all grease, dust, and dirt are removed. Make sure that the cleaning solvent used will not damage the finish on the wall surface.
Remove the clear protective film on the exposed side of the corner guard.
For 3/4” wing corner guards:
Place in desired location, holding the corner guard firmly. Using factory-supplied nails, hammer the nail through the corner guard into the wall.
For 1-1/8” - 3” wing corner guards:
Place in desired location, holding the corner guard firmly. Attach the corner guard by placing the provided self-tapping screws in the pre-drilled counter sunk holes and attach to the wall.
Wall surfaces must be clean, dry, and free from dust and grease. Wipe the wall surface with a solvent to assure all grease, dust, and dirt are removed. Make sure that the cleaning solvent used will not damage the finish on the wall surface.
Remove the clear protective film on the exposed side of the corner guard (clear corner guards only).
Peel off backing tape from one wing entirely, then peel back the tape partially on the second wing. Place wing with the fully exposed tape to the wall, then remove the remainder of the tape backing from the second wing. Press firmly along the entire length of the corner protector to ensure a good bond.
